- Print
- DarkLight
- PDF
OpenEdge Graphical Client has Stopped Working Fault Module Name MFC100.dll
Article summary
Did you find this summary helpful?
Thank you for your feedback
FIMS crashes with error, "OpenEdge Graphical Client has Stopped Working" listing the faulty module as 'mfc100.dll'.
Steps To Duplicate:
Launch FIMS or while working in FIMS see the error below
nswer:
This occurs due to the mfc100.dll being missing from c:\windows\syswow64 if you have a 64 bit computer. To resolve this, copy the mfc100.dll from either npo\dlc11\bin or npo\dlc11\netsetup and paste into c:\windows\syswow64. If you have a 32 bit computer then the DLL would need to go in c:\windows\system32.
It is best however for all workstations who use FIMS from the shared N drive to run net setup to be sure they have all of the correct files:
See step #4 of the following article:
It is best however for all workstations who use FIMS from the shared N drive to run net setup to be sure they have all of the correct files:
See step #4 of the following article:
Was this article helpful?